How to coordinate the relationship between scope and ballistics

According to the principle of ballistics, any sights at close distances, including mechanical sights, optical sights, inner red dot sights, lasers, etc., are low, and have exceeded the schedulable design. Usually, this distance is fundamental Not in the schedulable plan.

According to the principle of ballistics, any sights at close distances, including mechanical sights, optical sights, inner red dot sights, lasers, etc., are low, and have exceeded the schedulable design. Usually, this distance is fundamental Not in the schedulable plan.

If the impact point is always densely covered in the normal use range, the front and rear mirror ring pads can be used to fine-tune the angle between the aiming axis and the axis of the object being used. According to the principle, only when the walking accuracy exceeds the range It is the problem of the scope. When there is no doubt about the walking accuracy, it is attributed to the state of no calibration or over-range adjustment. The former can correct the impact point according to the adjustment, and the latter can change the target aiming interval if it is too close or too far beyond the application range. Select the appropriate aiming interval, and if the aiming axis is asymmetrical with the axis of the object being used (the angle between the axis of the rail groove of the object being used and the vertical line is different when it leaves the factory, the angle between the axis of the rail groove and the vertical line is different, so the It may or may not be possible for the sighting device to present this question) It only needs to be fine-tuned by the front and rear mirror ring gaskets to deal with it.